Difference between revisions of "Water Pump TDCI 115PS"

Revision as of 10:46, 28 October 2009

Water Pump Replacement on Mondeo 2.0 TDCI 115PS

When replacing the Water pump you could replace the belt and thermostat at the same time.

Minimum Parts Tool's Required

Flat, Positive & Torx Screwdrivers

Large Pliers

Small Socket set (with 8 & 10mm sockets + extn bars)

8 & 10mm ring Spanners

1/4" drive ratchet/suitable tool to release the tensioner

5L of replacement coolant.

New / Replacement Water Pump

Steps

1) Disconnect Battery (as always)

2) Drain system, into a bucket if you wish to re-use coolant.

3) Remover Air intake pipe's/top of box and disconnect from Turbo & engine breather (as in photo i replaced the metal once only clip with 2 cable ties).

4) Remove Thermostat housing, (disconnect pipes & 1 bolt)

5) Move EGR Solenoid out of the way (2x torx screws) & Remove EGR pipe (5 bolts, 2 front, 1 in middle on bracket, 2 at the rear)

6) Remove Power steering belt cover (1 bolt)

7) Release / Remove Power steering pump belt, using a 1/4" ratchet handle in the tensioner as a leaver to release the tension on the belt.

8) Disconnect Pipes Connected to water pump with pliers

9) Loosen 4 bolts on pump to engine

10) Loosen 2 bolts joining power steering pump to water pump

11) Remove all bolts that you just loosened

12) Separate water pump from PS pump (there is a shaft that runs between them, persuaded it to come out with a large flat screwdriver as leverage (see red arrows))

Re-Assembly

Re-assemble in reverse order, making sure you grease the shaft between the two pumps, and that you will need to re-use the Black thermostat attached to the side of the pump, i greased this too, this helped put it back in but also re-seal, I used my old gaskets as they were better quality and not damaged. When doing up the bolts between the pumps and from the water pump to the engine, loosely fit these and once all lined up and in place tighten...

Images to Assist

--Mutl3y 15:29, 28 October 2009 (UTC)