Registrations
We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.
If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum
Difference between revisions of "Door Handles - Removal Of Exterior"
| (4 intermediate revisions by 3 users not shown) | |||
| Line 17: | Line 17: | ||
|header2 = | |header2 = | ||
|label2 = Petrol/Diesel: | |label2 = Petrol/Diesel: | ||
| − | |data2 = ''' | + | |data2 = '''Both''' |
|header3 = | |header3 = | ||
|label3 = Estimated Cost: | |label3 = Estimated Cost: | ||
| Line 23: | Line 23: | ||
|header4 = | |header4 = | ||
|label4 = Difficulty? | |label4 = Difficulty? | ||
| − | |data4 = ''' | + | |data4 = '''Easy Skills''' |
|label5 = How long does this take? | |label5 = How long does this take? | ||
| − | |data5 = ''' | + | |data5 = '''About 10 mins per door''' |
}} | }} | ||
| − | == How to Remove MKIII Door Handles == | + | == How to Remove MKIII Exterior Door Handles == |
=== Method === | === Method === | ||
Latest revision as of 15:37, 22 April 2011
For more information, visit the Ford Mondeo forum on TalkFord.com, the definitive resource site covering all Fords from the present day to the 1970's.
 Overview Guide | |
| Ford Model: | Mondeo |
|---|---|
| Petrol/Diesel: | Both |
| Estimated Cost: | ???? |
| Difficulty? | Easy Skills |
| How long does this take? | About 10 mins per door |
How to Remove MKIII Exterior Door Handles
Method
The job should take about 10 mins per door to do.
1: Remove the cover cap from the edge of the door. This will give you access to the adjustment screw.
2: Pull the handle out to the full extent & unscrew until the handle remains extended. ( see note 1 below )
3: Remove the rear part of the handle, this will just lift out.
4: Pull back the handle towards the rear of the car & then pull outwards. The handle will now come free.
5: Refitment is reverse of the above.
note 1 - make sure you dont undo the screw too much as this will reverse the pin that holds the latch internals & cause problems for refitting - 2 turns should be more than enough for the internal pin to do its work & hold the latch mechanism open - this is why its important to check that the internal mechanism is being held properly & the exterior handle is loose before you remove the exterior handle.
should you have problems with refitting due to the pin not doing its job & letting the internal lever loose inside the door after the handle is removed then fishing wire or similar made into a loop can be used to poke through the hole in the door & onto the internal lever & pull it back allowing the external handle to be refitted properly again, the only other way is to remove the door card & the upper section of the internal weather seal & push the lever manually & refit the handle that way.
Pictures
The following pictures shows:
The Adjustment Screw
The Handle Removed
The Handle Re-fitted.
Your Privacy Choices