Registrations

We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.

If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum

Difference between revisions of "Seatbelt Reminder - Turning Off"

From www.FordWiki.co.uk
Jump to: navigation, search
(build date)
Line 2: Line 2:
  
 
=== Remember ===
 
=== Remember ===
Before starting this procedure, make sure that...
+
This only works on vehicles built from 4 February 2002. Before starting this procedure, make sure that: the handbrake's on, it's in Park or Neutral, the ignition is off, all doors are closed (and you're in the car), all the seatbelts are unbuckled and the headlamps are off.
The handbrake's on  
+
It's in Park or neutral.
+
Ignition is off.
+
All doors are closed (and you're in the car).
+
All the seatbelts are unbuckled.
+
The headlamps are off.  
+
  
 
=== Deactivating/Activating ===
 
=== Deactivating/Activating ===

Revision as of 04:52, 25 February 2008

Turning Off Seatbelt Reminder

Remember

This only works on vehicles built from 4 February 2002. Before starting this procedure, make sure that: the handbrake's on, it's in Park or Neutral, the ignition is off, all doors are closed (and you're in the car), all the seatbelts are unbuckled and the headlamps are off.

Deactivating/Activating

Turn the ignition switch to position II. (Do not start the engine).

Wait until the safety belt warning indicator turns off. (Approximately one to two minutes).

Note: The next 3 steps must be completed within 60 seconds or the procedure must be repeated. Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled.

Turn the headlamps ON then OFF.

Buckle then unbuckle the safety belt three times ending with the safety belt unbuckled. After this step the safety belt warning indicator will be illuminated for three seconds.

Within seven seconds of the safety belt warning indicator turning off, buckle then unbuckle the safety belt. This will enable the belt minder if disabled or disable belt minder if enabled.

The following sequence will confirm the belt minder is enabled: The safety belt warning indicator flashes four times per second for three seconds. Three seconds with the safety belt warning indicator off. The safety belt warning indicator flashes four times per second for three seconds again.

The safety belt warning indicator flashing four times per second for three seconds provides confirmation of belt minder disabled.

After confirmation, the deactivation/activation procedure is complete

Notes

1 If the vehicle doesn't have a seatbelt warning light, use the SRS (airbag) warning indicator instead.

2 If the seatbelt light doesn't normally come on until you move, proceed as above, without initially waiting for the belt warning indicator to go off (in this case, after the second three buckles, the indicator will flash a couple of times, instead of being illuminated for 3 seconds)

Specific vehicles

The following table lists specific vehicles, with which this procedure has been tried, and gives any additional vehicle specific information.

Year Engine Model Additional information
2004 Duratorq 2.0 TDCi Note 2 applies
2002 Duratorq 2.0 Ghia X

Submitted by imspanners

Updated by Guinness2702

Updated by Montyb 1909