Registrations

We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.

If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum

Difference between revisions of "Drivers Airbag"

From www.FordWiki.co.uk
Jump to: navigation, search
(New page: '''How to tighten a Mk 2 Drivers Airbag''' ''Tools Needed:'' <P> Torx 30 screwdriver (or some may require a Torx 25)</P> <P>''Procedure for tightening drivers airbag''</P> <P>The driv...)
 
Line 15: Line 15:
  
 
Then insert Torx screw driver into the hole and tighten up the screws by tightening towards the passenger side door.  This will then stop the airbag rattling and no need to remove the plastic around the column.
 
Then insert Torx screw driver into the hole and tighten up the screws by tightening towards the passenger side door.  This will then stop the airbag rattling and no need to remove the plastic around the column.
 +
 +
[[Category:Mondeo_Mk2]]

Revision as of 03:07, 31 January 2010

How to tighten a Mk 2 Drivers Airbag


Tools Needed:

Torx 30 screwdriver (or some may require a Torx 25)


Procedure for tightening drivers airbag

The drivers airbag is held on with 2 torx screws each side of the steering wheel in the center at the back of the wheel. Don't touch the outer holes on the steering wheel as these don't hold the airbag. Also their is no need to disconnect the battery, as it is quite safe to tighten the airbag, or just leave the car 15 - 20 mins and the airbag will disarm if you want extra safety.

Adjust the Steering wheel column so that it is slid out towards you

Turn the Steering wheel 90 degrees, so that the if you look on the back of the steering wheel, you can see the hole in the middle of the back of the steering wheel just slightly above the hazzard warning light switch.

Then insert Torx screw driver into the hole and tighten up the screws by tightening towards the passenger side door. This will then stop the airbag rattling and no need to remove the plastic around the column.