Registrations
We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.
If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum
Difference between revisions of "Intake Manifold Removal"
Compuwiz uk (Talk | contribs) |
Compuwiz uk (Talk | contribs) (→Removal) |
||
| Line 36: | Line 36: | ||
9. Detach the accelerator cable. | 9. Detach the accelerator cable. | ||
| − | + | 1 Detach the inner cable. | |
| − | + | 2 Turn the cable out of the bracket. | |
Detach the cable and position it to one side. | Detach the cable and position it to one side. | ||
| Line 93: | Line 93: | ||
20. Remove the intake manifold. | 20. Remove the intake manifold. | ||
| − | |||
=== Installation === | === Installation === | ||
Revision as of 16:53, 1 May 2008
Duratec HE Intake Manifold Removal Procedure
Removal
1. Detach the positive crankcase ventilation (PCV) hose and the vacuum hose from the engine upper cover.
2. Remove the engine upper cover.
3. Disconnect the battery ground cable.
4. Raise and support the vehicle.
5. Remove the oil level indicator lower retaining bolt.
6. Remove the intake manifold lower retaining bolt.
7. Lower the vehicle.
8. Detach the air cleaner outlet pipe from the throttle body (TB).
9. Detach the accelerator cable.
1 Detach the inner cable. 2 Turn the cable out of the bracket.
Detach the cable and position it to one side.
10. Disconnect the throttle position (TP) sensor and the idle air control (IAC) valve electrical connectors.
11. Disconnect the brake booster vacuum line from the intake manifold.
12. Disconnect the electrical connectors.
13. Detach the engine wiring harness from the intake manifold.
14. Remove the oil level indicator and tube.
15. Disconnect the vacuum hoses from the intake manifold.
16. Disconnect the engine air shut off valve, the manifold absolute pressure (MAP) sensor and the swirl plates solenoid valve electrical connectors.
17. Remove the intake manifold bolts (engine shown removed for clarity).
Detach the intake manifold from the cylinder head.
18. Disconnect the PCV hose from the intake manifold.
19. Detach the knock sensor (KS) electrical connector from the intake manifold.
20. Remove the intake manifold.
Installation
1. Note: Install new gaskets.
To install, reverse the removal procedure.
2. Initialize the door window motors.
Your Privacy Choices