Powerfold Mirrors With Puddle Lights Retro-fit

Required Parts

Facelift

Mirrors with Powerfold & Puddle Lights.

Powerfold Relay.

Adjustment Switch With Powerfold Position.

Pre-facelift

Same As Above +

Both Front Door Wiring Looms From A Facelift Mondeo.

Interior Front Door Plug From A Scrapped Mondeo for wires & connectors.

Check Below The Glovebox Fusebox For The Brown Relay Holder.

if no brown relay holder is in place then you will need the following too.

Brown Relay Holder with wires.

Fusebox Plug & wiring.

An Additional 5 wires & connectors for the door plug.

Fitting

Facelift

Remove Door Card

Remove Old Mirror Switch From Wiring & Plastic Surround

Refit New Switch To Plastic Cover & Plug Into The Door Loom

Unplug Mirror Wiring

Remove 3 Torx Screws For The Mirror ( remember to support the mirror on the outside when removing the last screw or you get end up with some bad luck )

Fit New Mirror Unit

Refit Door Card

Repeat For Door 2

Remove Glovebox

Insert The Relay

Refit The Glovebox

Pre-Facelift

Remove Door Card

Partially Remove The Foam Weather Seal

Uncouple Door Loom From Car

Uncouple Door Lock Mechanism & Window Motor.

Remove Wiring From The Door

Refit Facelift Door Loom Into The Door

Plug Window Motor & Door Lock Unit Back In

Refit ( Re-seal If Required ) The Inner Weather Seal

Remove Old Mirror Switch From Wiring & Plastic Surround

Fit New Switch To Plastic Cover & Plug Into The Door Loom

Unplug Mirror Wiring

Remove 3 Torx Screws For The Mirror ( remember to support the mirror on the outside when removing the last screw or you get end up with some bad luck )

Fit New Mirror Unit

Refit Door Card

Repeat For Door 2

Remove Glovebox

Insert The Relay

Refit The Glovebox

Add Puddle light Wiring to the interior Of the door Plug in the pin locations found below.

If You Need To Wire In The Powerfold Relay Holder Then You will Need The Following Info

Connector Locations

C54 = Drivers Side Upper Plug.

C52 = Passenger Side Door Plug.

C506 = on the rear of the fusebox ( top plug nearest the door on the back ).

Powerfold relay pin layout

Pin 1 - C54 Pin 6 & C52 Pin 10 ( Powerfold ) Pin 2 - C54 Pin 10 ( Switch ) Pin 3 - C54 Pin 7 & C52 Pin 1 ( Powerfold ) Pin 4 - C506 Pin 12 ( Power Feed ) Pin 5 - Ground

Puddle Light Wiring

Feeds Taken From The Front Footwell Lights Are easiest

Drivers Side = C54 Pin 12 & Pin 13 Passenger Side = C52 Pin 6 & Pin 7

Submitted By Compuwiz_uk