Help:Starting a new page

A simple iPod / iPhone install

Here i will show you how to install a quick and easy iPod / iPhone instalation, useing this method will allow you to charge your device at the same time as listning to your music and videos and also give you far better sound quallity than the headphone socket!

To start you will need a 3.5mm to 2 RCA adapter lead, i used a 2m lead and had about 2 foot of excess wire when all done any lead will do, however i used a sheilded type as it was just as cheap as a normal one.

next you will need to pop onto EBAY and get yourself one of these:

its a iPhone to RCA lead with 5v charge, now its important that you get the 5v version as this will charge the latest iPods and iPhones (including 3G and 3Gs) these sell for around 8-10 pounds and are mainly available from hong kong (check the sellers feedback to ensure you get a worry free sale, should take around 7-14 days to arive)

To link the two together you will recuire a RCA to RCA adapter again these are available on ebay for a few quid

The 3.5mm jack end goes into your AUX socket in your glovebox, tuck the wire behind the plastic trim down the passengers side of the center console

Next you will need to make a hole in your arm rest box, i used a 14mm drill bit in a hand drill check there are no wires the end of the drill can snag, on the inside, you can view this when removing the ashtray / cup holder trim

     -----> front ----->

pass the RCA end of the iPhone lead through the hole and fish it out from the other side where the cup holder sat.

tie a lose knot in the wire befor doing the next step, this will prevent you pulling the conections apart inside by pulling the wire out too far,

you will notice the negative wire (black) has a eyelet terminal, i removed the mounting skrew from where the cup holder sits and placed the eyelet inbetween the plastic and metel frame, so the skrew passes through the eyelet.