Coilovers - How to fit to a Ka Mk1

The Ford Ka hit our roads in 1996, and and it's currently on its second revision which was launched in 2008.
For more information, visit the Ford Ka forum on MyKa.org, the largest and most comprehensive Ford Ka website in the UK.

---

Overview Guide (Demonstration)
Ford Model:	Ka
Petrol/Diesel:	Petrol
Estimated Cost:	N/A
Difficulty?	Medium
How long does this take?	4-8 hours

Tools: Jack Axles stands x2 Sockets and ratchet (15,17,18,19 mm) Spanners (15,17,18,19mm) Allen key for tops of struts (or an allen bit in a socket is better) Grips BIG hammer.

IMPORTANT - ENSURE CAR IS SAFELY SUPPORTED WITH JACK AND AXLE STANDS BEFORE COMMENCING

you won't need spring compressors, just wind the coil platforms right down before you fit the springs, then wind up again once the top nuts on.

Basically, for rears: Loosen the top nuts on the shocks (just leave hanging on by a couple of turns) Support the car on stands (on the body not the beam) Remove wheels Support the beam with a jack Unclip the handbrake hoses from the metal clips on the beam Undo the 2 eye mount bolts Lower the beam with the jack Support each shock with one hand and remove the top nut with the other, lower the shock away. - Repeat other side. Put the old top mounts on the coilovers (just drop on IIRC) Lift in, slide on top cup, screw on a nut at the top a few turns to hold. Repeat other side. Jack the beam up till you can refit the bottom bolts (don't tighten all the way) Set the spring platform height (quite high to start then wind down) Clip the handbrake cable back into the clips. Lower car to ground, torque bottom bolts, tighten top nuts.

Front: Loosen top nuts. Jack car up (both sides at the same time is easier to take the tension off the anti roll bar) Remove wheels Undo and remove the top of the drop link from the strut, unclip brake hose. Undo and remove strut clamp bolt Tap (smack with a hammer) the hub down away from the strut (You can get a cold chisel in the opening at the back to loosen things up) Hold strut, undo top nut and lift away. Bearings and top mounts on the coilovers, lift into position, refit everything.