Registrations

We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.

If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum

Search results

Jump to: navigation, search
  • ...In all Zetec Focuses, throttle position is used to control the open/closed loop transition and also the idle/part throttle transition. It can be logged in ...coolant temp also affects cold start functions including the first closed loop transition. On the regular Zetec Focus, there is a sensor that reads the me
    12 KB (2,153 words) - 15:23, 27 November 2011
  • ...CHT sensor has not achieved the required temperature level to enter closed loop operating conditions within a specified amount of time after starting engin ...O2S upstream and downstream switch rate and amplitude. Under normal closed loop fuel conditions, high efficiency catalysts have oxygen storage which makes
    103 KB (16,794 words) - 04:13, 3 March 2011
  • The next thing to do involves the purple loop! (Left Picture) And again with the original on the left and the new one on Locate the position of the original purple loop. It should be taped back just behind the original light switch and is fairl
    3 KB (561 words) - 20:05, 20 February 2011
  • * P0125 Insufficient Coolant Temperature for Closed Loop Fuel Control * P1148 Closed Loop Control (Bank 1)
    52 KB (7,232 words) - 15:54, 22 April 2011
  • ...and then tied a looped knot about 10-15mm from this point, so there was a loop and knot and one end and two free ends at the other. ...ither side, and then squeeze the the cord lock and slide it up the elastic loop until it is a tight fit. Repeat this at the other side and your umbrella is
    4 KB (667 words) - 09:41, 20 September 2011
  • ...efficiency of the AC system is dependant on how much refrigerant is in the loop. Over time this can leak out slightly and you find that even on the lo sett
    6 KB (992 words) - 15:41, 20 July 2017
  • Loop the cable towards the pillar trim (4. above).
    5 KB (864 words) - 19:02, 20 February 2011
  • Pic 2 - is a close up of the relay showing a loop from one pin to another ( presumably its the ground wire)
    8 KB (1,414 words) - 15:47, 22 April 2011
  • ...door after the handle is removed then fishing wire or similar made into a loop can be used to poke through the hole in the door & onto the internal lever
    3 KB (411 words) - 15:37, 22 April 2011
  • Try to pull a little loop of this grey/white wire out of the loom. You're going to cut this, and sold
    6 KB (973 words) - 14:57, 22 April 2011
  • ...screwdriver & into the vent space, then just thread it through the central loop ready for when you insiert the sensor after fitting the grill & remove the
    12 KB (2,165 words) - 12:08, 13 April 2011
  • *Emission controls Closed-loop; 3-way catalytic converter with close-coupled catalyst
    4 KB (562 words) - 04:00, 3 March 2011

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)