Search results

Create the page "Lip" on this wiki! See also the search results found.

• Bomz Air Induction Kit (Mondeo Mk1/2/3, Focus Mk1/2)
  ...n. File away any loose bits of plastic. Note that you will need to leave a lip of approximately 2-3mm, so avoid making the cut absolutely flush with the r ...from the aerosol and file out a crescent shape so that when mounted on the lip mentioned above it is relatively flush with the rest of the housing. I foun
  4 KB (720 words) - 19:00, 20 February 2011
• Subframe Bushes
  ...supplied with the bushes. Make sure they go far enough in so that the top lip on the bush goes right through and locates over the top edge of the old ste ...r the frame a little so that the powerflex bush will go right through (the lip mentioned above).
  3 KB (621 words) - 14:55, 22 April 2011
• Folding Mirrors With Remote Key
  ...and then the brown connector. They just slide on, but there is a retaining lip which prevents the connector from sliding off. A small inspection torch is
  8 KB (1,354 words) - 15:06, 22 April 2011
• UIM & LIM Removal And Cleaning
  ...will lift a securing spring inside the metal lipped join over the internal lip that is holding it in place.
  12 KB (2,137 words) - 20:26, 23 April 2011
• Mk2 RSAP Bumpers
  ...last bit depends on the year of the car, mine had 2 brackets on the bottom lip of the bumper, connecting to the fuel tank/body. The earlier ones did not h
  4 KB (640 words) - 20:10, 20 February 2011
• Fog Lights - Mk2
  ...hard on the outer ring (the best way is to put your fingers under the top lip and tug!)
  3 KB (561 words) - 20:05, 20 February 2011
• Grille Mod - Mk2
  A little trimming, but allowing a lip. This template is slightly bigger that the opening in the black part so you
  3 KB (602 words) - 20:07, 20 February 2011
• ST220 Buyers Guide
  Rust forming on bottom lip of doors
  589 B (80 words) - 04:19, 3 March 2011
• Centre console trim, dashboard controls and head unit removal - Mk4
  '''(3) Pull''' the trim '''up''': grasp lip of the trim with forefinger and thumb near cup holders at handbrake side an
  26 KB (4,107 words) - 16:26, 9 July 2013
• Alternator Rebuild - Visteon IS7T
  ...n the internal face of the bearing from the other side. This did crack the lip on the spacer bush inside but I didn't see that being an issue. I pressed t
  16 KB (2,884 words) - 04:06, 10 October 2013