Search results

Create the page "O" on this wiki! See also the search results found.

• Airbag Fault Codes
  o No first horn beep: o No second horn beep:
  16 KB (2,456 words) - 23:47, 10 March 2011
• Acronyms and Abbreviations
  === H to O === O/S: Off Side - Right Hand side of car
  11 KB (1,611 words) - 00:26, 14 December 2010
• V6 Cold starting issues
  ...as you'll risk damaging the mating surface where the manifold sits. Old 'O' rings tend to swell with age, making a very snug fit between the fuel rail ...s, taking care not to damage the electrical contacts or anywhere near the 'O' rings. You won't need much pressure on the injectors themselves, the forc
  10 KB (1,722 words) - 19:49, 20 February 2011
• Fuel Pump Change TDCi
  ...an spin the drivers wheel, the hole in the timing spocket needs to be at 1 O'Clock once In the correct place. the car can be lowered down.
  4 KB (706 words) - 15:01, 27 November 2011
• Folding Mirrors With Remote Key
  ...on (ie neither left nor right mirror selected, tip the switch downwards (6 o'clock position) to fold and the same again to unfold. This action by the sw
  8 KB (1,354 words) - 15:06, 22 April 2011
• V6 Head Gasket Replacement
  ...ley to remove the crank pulley , if done right the key should be in the 11 o’clock position. ...e crank shaft ( using the bolt )( CLOCKWISE ONLY ) so the key way is the 3 o’clock position
  16 KB (2,885 words) - 20:28, 23 April 2011
• Bulbs Types (Mondeo Mk1/2/3)
  ...im wrong on this one) <<< you are definately not wrong on a pre facelift :O)
  3 KB (386 words) - 05:43, 20 March 2013
• Ford Diagnostic Codes List
  ...ition A fuel tank pressure change greater than a minus (-) 7 inches of H 2 O in 30 seconds has occurred with purge (fuel vapor) flow less than 0.02 poun
  103 KB (16,794 words) - 04:13, 3 March 2011
• Alternator Replacement (Mondeo Mk1 TD)
  ...e studs which secure the intercooler to the engine, and remove (check the "O" rings where it slots into the turbo and if necessary fit new ones&nbsp;- a
  3 KB (574 words) - 01:35, 7 February 2011
• MAF (Mass Air Flow) Sensor Clean 130 TDCI
  ...sor back into its hole in the inlet ducting. A smear of lube on the rubber O ring seal at the top of the sensor may help it home (though not essential).
  7 KB (1,150 words) - 22:26, 20 February 2011
• VIN Plate Information
  * O Octane Blue
  6 KB (908 words) - 20:22, 20 February 2011
• Oil and Filter Change
  Halford's sell the filter along with both rubber O-rings needed to replace the ones from the filter housing and the drian plug
  4 KB (713 words) - 19:30, 20 February 2011
• DAB Radio Retrofit
  Using a wire coat hanger, feed the cable through to the O/S A pillar and follow it down reusing the original clips to the join.
  5 KB (834 words) - 12:12, 13 March 2012
• Terms Of Use
  (o) consist of or contain any instructions, advice or other information which
  15 KB (2,506 words) - 02:18, 2 March 2011
• LED's in door handles
  ...s not in the driver’s door. You could however trace a wire from the rear O/S door to the
  4 KB (759 words) - 13:49, 5 December 2011
• Injector Leak-Off Test
  ...nto any hard material. Depth isn't critical but needs to permit the little O ring to enter. The material could be hard wood, plastic or in my case metal
  5 KB (813 words) - 09:07, 24 February 2016
• Alternator Rebuild - Visteon IS7T
  *Remove o/s wheel, remove cover in wheel arch (4x 10mm bolts)
  16 KB (2,884 words) - 04:06, 10 October 2013